Hypertherm Powermax65 SYNC - Replace the output inductor

Service Procedures for the Magnetics
6
Powermax65/85 SYNC Service Parts and Procedures 810440 127
Replace the output inductor
For kit contents, refer to Power supply interior, magnetics on page 33.
Remove the output inductor
1. Set the plasma power supply switch to OFF (O),
disconnect the power cord from the power source,
and disconnect the gas supply.
2. Remove the plasma power supply cover and the
component barrier. Refer to page 49.
3. Remove the end panel bracket. Refer to page 53.
4. Loosen the front panel. Refer to page 55.
5. Remove the electrode wire screw from the
power PCB.
6. Remove the output inductor wires screw from
the power PCB.
7. Remove the 2 mounting screws from the output
inductor.
8. Pull the electrode wire through the protective sheath .
RED
ORG
RED
B
R
WORK
LEAD
T
TP8
W
1
2
1
2
3
4
3
4