Service Parts
40 810440 Service Parts and Procedures Powermax65/85 SYNC
Descriptions of warning label icons
This warning label is affixed to some plasma power supplies. It is important
that the operator and maintenance technician understand the intent of
these warning symbols as described. The descriptions at right are
numbered the same as the symbols on the label.
1. Cutting sparks can cause
explosion or fire.
1.1 Do not cut near flammables.
1.2 Have a fire extinguisher nearby
and ready to use.
1.3 Do not use a drum or other
closed container as a cutting
table.
2. Plasma arc can injure and burn;
point the nozzle away from
yourself. Arc starts instantly when
triggered.
2.1 Turn off electrical power before
disassembling torch.
2.2 Do not grip the workpiece near
the cutting path.
2.3 Wear complete body protection.
3. Hazardous voltage. Risk of
electric shock or burn.
3.1 Wear insulating gloves. Replace
gloves when wet or damaged.
3.2 Protect from shock by insulating
yourself from work and ground.
3.3 Disconnect power before
servicing. Do not touch live parts.
4. Plasma fumes can be hazardous.
4.1 Do not inhale fumes.
4.2 Use forced ventilation or local
exhaust to remove fumes.
4.3 Do not operate in closed spaces.
Remove fumes with ventilation.
5. Arc rays can burn eyes and injure
skin.
5.1 Wear correct and approved
protective equipment to protect
head, eyes, ears, hands, and
body. Button shirt collar. Protect
ears from noise. Use welding
helmet with the correct shade of
filter.
6. Become trained. Only qualified
personnel should operate this
equipment. Use torches specified
in the manual. Keep non-qualified
personnel and children away.
7. Do not remove, destroy, or cover
this label. Replace it if it is
missing, damaged, or worn.
www.hypertherm.com/weeewww.hypertherm.com/weee
To Next Page
Loading...
Need help?
General
