Hypertherm Powermax65 SYNC User Manual

Service Procedures for the Gas Line
4
92 810440 Service Parts and Procedures Powermax65/85 SYNC
Replace the 90° gas tube fitting
For kit contents, refer to Plasma power supply interior, fan side on page 21.
1. Set the plasma power supply switch to OFF (O), disconnect the power cord from the power
source, and disconnect the gas supply.
2. Remove the plasma power supply cover and the component barrier. Refer to page 49.
3. Push-to-disconnect the long gas tube from the 90° degree gas inlet fitting.
4. Push-to-disconnect the 90° gas inlet fitting from the torch quick-disconnect receptacle .
5. Push-to-connect the new 90° gas inlet fitting to the torch quick-disconnect receptacle.
6. Push-to-connect the long gas tube into the new 90° gas inlet fitting.
1
2
1
2

Hypertherm Powermax65 SYNC Specifications

General

Brand	Hypertherm
Model	Powermax65 SYNC
Category	Welding System
Language	English