Hypertherm Powermax65 SYNC User Manual

Service Procedures for the Cover, Panels, and Connectors
3
Powermax65/85 SYNC Service Parts and Procedures 810440 53
Replace the end panel bracket
Remove the end panel bracket
1. Set the power switch on the plasma power supply to OFF (O), disconnect the power cord, and
disconnect the gas supply.
2. Remove the plasma power supply cover and the component barrier. Refer to page 49.
3. Lift the end panel bracket off of the plasma power supply.

Hypertherm Powermax65 SYNC Specifications

General

Brand	Hypertherm
Model	Powermax65 SYNC
Category	Welding System
Language	English