Hypertherm Powermax65 SYNC User Manual

Service Procedures for the Gas Line
4
82 810440 Service Parts and Procedures Powermax65/85 SYNC
Replace the air filter bowl, O-ring, and filter element
1. To replace the filter element, twist and pull the plastic fittings away from the filter element,
approximately a 1/4 turn. Set the fittings aside. Discard the used filter element.
2. Put the new air filter element in the plastic fittings. Twist the plastic fittings until they lock
together, approximately a 1/4 turn.
3. If the air filter bowl will not be replaced:
 Clean the bowl and O-ring of any oil, dirt, or other contamination. Apply a thin layer of
silicone lubricant on the O-ring.
 To replace the O-ring, discard the used O-ring. Put the thick O-ring at the top of the filter
bowl.
4. To replace the air filter bowl, discard the old air filter bowl.
5. Put the filter element inside the air filter bowl. Push down on the top plastic fitting until you hear
a click.
1
1
2
2

Hypertherm Powermax65 SYNC Specifications

General

Brand	Hypertherm
Model	Powermax65 SYNC
Category	Welding System
Language	English