Hypertherm Powermax65 SYNC - Attach the Rear Panel of the Plasma Power Supply

Service Procedures for the Cover, Panels, and Connectors
3
58 810440 Service Parts and Procedures Powermax65/85 SYNC
Attach the rear panel of the plasma power supply
1. Put the fan side of the plasma power supply on a clean, dry, and flat surface.
2. Push the rear panel onto the bottom of the plasma power supply.
3. Install the screws that attach the rear panel to the bottom of the
plasma power supply. Tighten the screws to 2.3 N·m (20 lbf·in).
4. Put the plasma power supply in an upright position.
5. Push-to-connect the gas tube to the air filter.
6. Install the end panel bracket. Refer to page 54.