Hypertherm Powermax65 SYNC User Manual

Service Parts
2
16 810440 Service Parts and Procedures Powermax65/85 SYNC
Powermax85 SYNC

You can make a work lead for the Powermax65 SYNC and
Powermax85 SYNC by installing the 008337 hand clamp or the 428921
C-style clamp on the approved amperage ring terminal work lead from
Hypertherm. Make sure that you use a work lead that is the correct
amperage for your plasma power supply.
For replacement procedures, refer to Replace the work lead connector on page 67.
Item Part number Description
1 223035 85 A work lead with hand clamp, 7.6 m (25 foot)
1 223034 85 A work lead with hand clamp, 15 m (50 foot)
1 223033 65 A / 85 A work lead with hand clamp, 23 m (75 foot)
3 223209 85 A work lead with ring terminal, 7.6 m (25 foot)
3 223210 85 A work lead with ring terminal, 15 m (50 foot)
3 223211 65 A / 85 A work lead with ring terminal, 23 m (75 foot)
4 008337 Ground hand clamp: 300 A
5 428921 Kit: C-style clamp with hardware
228709 Kit: Work lead connector

Hypertherm Powermax65 SYNC Specifications

General

Brand	Hypertherm
Model	Powermax65 SYNC
Category	Welding System
Language	English