Hypertherm Powermax65 SYNC - Page 72

Service Procedures for the Cover, Panels, and Connectors
3
72 810440 Service Parts and Procedures Powermax65/85 SYNC
8. Push-to-disconnect the 90° gas inlet fitting from the torch
quick-disconnect receptacle.
9. Remove the following components from the torch
quick-disconnect receptacle:
 Retention nut
 Ring terminal
 Washer
10. Push the torch quick-disconnect receptacle out
through the torch quick-disconnect receptacle housing.
11 . Remove the 4 screws from the torch quick-disconnect
receptacle housing.
12. Remove the torch quick-disconnect receptacle housing from
the front panel.
5
5
6
7
8
6
7
8
9
10
9
10