IDEC OpenNet series User Manual

25: DEVICENET SLAVE MODULE
OPENNET CONTROLLER USER’S MANUAL 25-3
DeviceNet Slave Module Parts Description
(1) Module ID FC3A-SX5DS1 indicates the DeviceNet slave module ID.
(2) DIP Switch 10-pole DIP switch for setting node address (MAC ID), data rate, output hold/load off, and physical
port number
(3) Network Interface Connector For connecting the DeviceNet communication cable
(4) Color Label A five-color label is located beside the connector on the DeviceNet slave module. Connect each of
the five different-color wires of the DeviceNet communication cable to the terminal of a matching
color.
(5) Status LED Indicates operating status
Module Name DeviceNet Slave Module
Type No. FC3A-SX5DS1
Label and Wire Insulation Color Name
Black V–
Blue CAN_L
Bare Wire Drain
White CAN_H
Red V+
Indicator Status Description
POW
(power)
— OFF Module power OFF
Green ON Module power ON
MNS
(module/network status)
— OFF Power OFF or Dup_MAC_ID test not completed
Green
Flash Normal operation (communication not established)
ON Normal operation (communication established)
Red
Flash Minor fault (temporary network error)
ON Critical fault
IO
(I/O status)
— OFF I/O inactive
Green ON I/O active
Red
Flash Minor fault
ON Critical fault
Expansion Connector
(1) Module ID
(5) Status LED
(2) DIP Switch
(3) Network Interface Connector
(4) Color Label
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com

IDEC OpenNet series Specifications

General

Brand	IDEC
Model	OpenNet series
Category	Controller
Language	English