IDEC OpenNet series User Manual

2: MODULE SPECIFICATIONS
2-38 OPENNET CONTROLLER USER’S MANUAL
DeviceNet Slave Module
The OpenNet Controller can be linked to DeviceNet networks. For communication through the DeviceNet network, the
DeviceNet slave module is available.
For details about the DeviceNet slave module and DeviceNet communication system, see page 25-1.
DeviceNet Slave Module Type Number and Weight
Parts Description
(1) Module ID FC3A-SX5DS1 indicates the DeviceNet slave module ID.
(2) DIP Switch 10-pole DIP switch for setting the node address (MAC ID: media access control identi-
fier), data rate, output hold/load off, and physical port number
(3) Connector Network interface connector for connecting an input communication cable
(4) Status LED Indicates operating status
(5) Expansion Connector Connects to CPU and other modules.
Module Name DeviceNet Slave Module
Type No. FC3A-SX5DS1
Weight (approx.) 180g
POW
POWER
Green ON: Power is on
MNS
MODULE/NETWORK STATUS
OFF: Duplicate MAC ID test not completed
Green Flash: Normal operation (not communicating with master)
Green ON: Normal operation (communicating with master)
Red Flash: Minor fault (e.g. timeout)
Red ON: Critical fault (e.g. duplicate MAC ID)
IO
I/O STATUS
Green ON: Normal operation
Red ON: Fault
(1) Module ID
(4) Status LED
(2) DIP Switch
(3) Connector
(5) Expansion Connector
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com

IDEC OpenNet series Specifications

General

Brand	IDEC
Model	OpenNet series
Category	Controller
Language	English