IDEC OpenNet series User Manual

26: LONWORKS INTERFACE MODULE
26-24 OPENNET CONTROLLER USER’S MANUAL
Example:
When the transmit and receive bytes are set to 3 using WindLDR (on the Open Bus page selected from Configure > Func-
tion Area Settings), only 24-point type declared network variables (nv_i24 and nv_o24) and the network variables shown
in the table below can be used. Then, link registers listed below can be used for transmission and receiving.
Structure Name Structure Used For
BIT16_DAT
typedef struct {
unsigned char dat[2];
}BIT16_DAT
16-point outputs, 8 bits × 2
BIT24_DAT
typedef struct {
unsigned char dat[3];
}BIT24_DAT
24-point outputs, 8 bits × 3
BIT32_DAT
typedef struct {
unsigned char dat[4];
}BIT32_DAT
32-point outputs, 8 bits × 4
BIT40_DAT
typedef struct {
unsigned char dat[5];
}BIT40_DAT
40-point outputs, 8 bits × 5
BIT48_DAT
typedef struct {
unsigned char dat[6];
}BIT48_DAT
48-point outputs, 8 bits × 6
BIT56_DAT
typedef struct {
unsigned char dat[7];
}BIT56_DAT
56-point outputs, 8 bits × 7
BIT64_DAT
typedef struct {
unsigned char dat[8];
}BIT64_DAT
64-point outputs, 8 bits × 8
b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0
L*00
nv_i8[1] nv_i8[0]
L*01
cannot be used nv_i8[2]
L*04
nv_o8[1] nv_o8[0]
L*05
cannot be used nv_o8[2]
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com

IDEC OpenNet series Specifications

General

Brand	IDEC
Model	OpenNet series
Category	Controller
Language	English