IEMCA Smart 320 Tp - 6.5.5 Mode of performing a cycle in the STEP BY STEP function

EN
6 - USE AND OPERATION SMART320
6 - Pag. 18 / 22
6.5.5 Mode of performing a cycle in the STEP BY STEP function
Foreword
This mode may be used for many reasons, as for instance:
• to open the guide channels;
• to check a complete bar change cycle;
• to check the bar feeder mechanics;
• to load a single bar so as to check the facing;
• et cetera.
Procedure
1 press to start the bar feeder;
• check that the guide channels of the bar feeder are
closed. If not, close the guide channels in manual
mode.
2 press
then to select the semiautomatic
mode;
3. press
, the bar feeder performs the first step
(bar pusher return);
4 press
, the bar feeder performs the second step,
and so on.
Bar feeder in stand-by
AUTO or MANUAL?