IEMCA Smart 320 Tp - 7.2 SCHEDULED MAINTENANCE
; 7.2.1 Revolving tip and collet - Check

7 - BAR FEEDER MAINTENANCE SMART320
EN
7 - Pag. 3 / 6
7.2 SCHEDULED MAINTENANCE
Scheduled maintenance
Frequency
Hours
Machine section
Operation to be
carried out
200 1250 2500
Periodic
ally
Every
year
Cycles
Revolving tip and collet Wear check •
Half-bushes Wear check •
Oil level check •
Lubrication system
Oil change •
Guide channels
Integrity and
cleanness check
•
Lubrication •
Feeding chain
Tensioning check •
Air filter Check •
PLC battery Replacement •
Safety devices
Check efficiency
(see ”safety devices”)
•
7.2.1 Revolving tip and collet - Check
• Remove the bar pusher, as described in
paragraph "Guide channels, half-bushes, bar
pusher and collet - Replacement", Chap 5.
• Check that the revolving tip (A) can turn
freely without excessive backlash.
Also check that collet (B) is in good condition.