IEMCA Smart 320 Tp - 6.8.2 Machining type change without guide change

EN
6 - USE AND OPERATION SMART320
6 - Pag. 22 / 22
6.8.2 Machining type change without guide change
• Replace the collet (“Guide channels, half-bushes, bar pusher and collet – Replacement”,
Chap.5)
- adjust the half-bushes;
• Adjust the bar guide plates ("Bar guide plates - Adjustment", Chap 5).
• Check all the working parameters on the keyboard.
• Prepare the lathe for a new machining cycle.
• Start the automatic working cycle (§ "Automatic cycle start" Chap 6).