IEMCA Smart 320 Tp - 6.6 BAR FEEDER STOP

6 - USE AND OPERATION SMART320
EN
6 - Pag. 19 / 22
6.6 BAR FEEDER STOP
BAR FEEDER EMERGENCY STOP
WARNING – CAUTION:
if the emergency stop is activated whilst the lathe is working, before restarting
the working cycle, check that no dangerous conditions have been created due to
the sudden stop.
Example: if the tool was removing chips, before restarting the lathe, distance
the tool from the piece.
• To stop the bar feeder in emergency, press one of the emergency buttons of the bar feeder
or lathe.
BAR FEEDER STOP AT THE WORKING CYCLE END
WARNING – CAUTION:
when stopping the machine normally, do not use the emergency buttons.
• Complete the operations in your working schedule.
• Stop the bar feeder by pressing
.
• Stop the lathe.
• Turn the main power switch to O (OFF).