IEMCA Smart 320 Tp - 10.1 GUIDE CHANNELS AND BAR PUSHER - TABLE

EN
10 - GUIDE CHANNELS-BAR PUSHER-REVOLVING TIPS SMART320
10 - Pag. 2 / 8
10.1 GUIDE CHANNELS AND BAR PUSHER - TABLE
The choice of the guide channels and the bar pusher must be made according to the diameter
of the bar to be machined. The bar feeder is usually supplied with a bar pusher whose diameter
is equal to the maximum bar passage of the lathe. Sometimes, in order to ensure the best
working conditions, the use of a bar pusher with a smaller diameter may be necessary.
A Guide channels
B Bar pusher
C Revolving tip
D Collet
E Bar