EN
4 - HANDLING AND INSTALLATION SMART320
4 - Pag. 6 / 26
4.4 BAR FEEDER - INSTALLATION
Before carrying out the bar feeder installation, check the lathe stability; make sure that it is
firmly fixed to the ground and that the spindle axis is perfectly in horizontal position.
4.4.1 Backing plates and support feet - Installation
• Position the bar feeder next to the lathe.
• Keep it lifted and install the plates (A) and
feet (B) in the positions shown in the figure.
4.4.2 Height - Adjustment
The bar feeder is normally supplied with the
working axis height adjusted to the lathe height.
However, if an adjustment is needed, proceed as
follows:
• remove the 8 screws (A) from the plates (B) on
the outer side of bar feeder feet.
• fix the plates with the screws (A) on the
suitable position to reach value "X" (see the
“Working axis height” table, Ch. 2).
• repeat these steps also in the feet inner plates
(C).
To Next Page
Loading...
