EN
6 - USE AND OPERATION SMART320
6 - Pag. 8 / 22
6.3 LIGHT INDICATOR DESCRIPTION
Green light (OPT): signals that the bar feeder is
working in automatic mode.
Red light (OPT): signals that the bar feeder is in
stopping conditions, or that it is working in manual
mode.
Blinking blue light (OPT): indicates that the bar
feeder is carrying out the bar change.
6.4 BARS TO BE MACHINED - FEATURES AND PREPARATION
WARNING – CAUTION:
do not load bars having sizes different from those recommended by the
manufacturer (see reference table in § Chap. 5).
Clean the bar surface before loading bars.
INFORMATION:
the bar must not have a straightness defect above 0.5 per 1,000.
Please find hereafter some advices to optimise the bar feeder performances.
Usually it is not necessary to perform preliminary operations on the bar ends, but to obtain
optimum results during loading, it is advisable to chamfer them.
To Next Page
Loading...
