EN
4 - HANDLING AND INSTALLATION SMART320
4 - Pag. 22 / 26
4.8.3 FUNCTION SIGNALS
The bar feeder can send and receive all the signals which are necessary to its correct operation.
These signals are managed by a PLC, and can be grouped into: inputs (signals from lathe to bar
feeder) and outputs (signals from bar feeder to lathe).
The signals that have been implemented are the result of our long experience and allow the
connection with every type of lathe: it is therefore possible that only some of them are used.
IMPORTANT:
for any other information you may need, please refer to the interface wiring
diagram or contact us: our Customer Service and Engineering Department are
always at your disposal.
To Next Page
Loading...
