EN
5 - ADJUSTMENT AND SETUP SMART320
5 - Pag. 2 / 20
5.1 ADJUSTMENT AND SETUP - FOREWORD
DANGER - WARNING:
do not perform any adjustment when the bar feeder is running unless expressly
requested in the manual.
In addition to normal adjustments throughout its service life, this bar feeder also needs set-up
according to the type of operation. According to bar size and type of machining, setting up may
also include replacement of a few components. These operations are listed and then described
below.
5.2 GENERAL ADJUSTMENTS - FOREWORD
Including all the necessary adjustments for a good feeder operation. They may become
necessary after maintenance, trouble fixing or component replacement.
5.2.1 Feeding chain - Adjustment
Turn the tension screw (A) on the front plate of bar feeder to adjust the tension of the chain
driving the bar pusher.
After some bar feeder operating hours, the chain tension has to be checked.
The chain must be adjusted as follows:
• Loosen both screws (B) and adjust the chain tension by turning screw (A).
• Restore the bar feeder initial operating conditions.
To Next Page
Loading...
