IEMCA Smart 320 Tp - 6.1 CONTROL DESCRIPTION

EN
6 - USE AND OPERATION SMART320
6 - Pag. 2 / 22
6.1 CONTROL DESCRIPTION
INFORMATION:
From the keyboard it is possible to start the bar feeder in automatic mode, even
when lathe 'MAN/AUT' signal is in Manual mode.
INFORMATION:
When the bar feeder is in Automatic mode, the bar feeding is possible only when
the Lathe ‘MAN/AUT' signal is in Automatic mode.
INFORMATION:
By pressing the Manual mode button it is possible to prevent the lathe from
starting the bar feeder in automatic mode.