IEMCA Smart 320 Tp - 8.3 FEEDING INTO COLLET ΠFailures
; 8.4 BAR FEEDING - Failures

8 - TROUBLES – CAUSES - SOLUTIONS SMART320
EN
8 - Pag. 3 / 4
8.3 FEEDING INTO COLLET – Failures
TROUBLES CAUSES SOLUTIONS
Collet diameter is not suitable
for bar diameter
Replace the collet
The bar fails to enter into the
collet
Excessive rag on bar fore end Eliminate rag on bars before loading
8.4 BAR FEEDING - Failures
TROUBLES CAUSES SOLUTIONS
Difficult bar introduction into
lathe spindle
Bar feeder not aligned with
lathe
Check and correct alignment
Difficult bar introduction into
lathe collet
Excessive rag on bar fore end Eliminate rag on bars before loading