EN
3 - SAFETY – GENERAL INFORMATION SMART320
3 - Pag. 4 / 4
3.4 USE AND OPERATION - Safety
• The working area around the bar feeder must always be kept clean and uncluttered so as to
allow performing the bar loading phase without encountering obstacles or dangers, and to
allow immediate access to the emergency devices.
It should also be kept clean and free from oil materials that may make the surface slippery thus
creating a dangerous condition for the operator.
• Perform the starting sequence of the working cycle as recommended.
• Do not put hands or anything else near or inside the moving parts or parts in tension.
• Remove bracelets, watches, rings and ties.
• If necessary, use strong work gloves with five fingers, which do not reduce the grip
sensitivity or power.
• Wear work shoes as well as personal protection devices provided for by the safety
regulations in force in all countries.
• Inform the maintenance personnel of any operating anomalies.
• Before starting the bar feeder, make sure that there is no personnel engaged in servicing or
cleaning the machine.
3.5 BAR FEEDER MAINTENANCE - Safety
• Do not allow unauthorized personnel to carry out maintenance operations.
• Read this manual carefully before carrying out maintenance operations.
• Do not lubricate, repair or adjust the bar feeder while running, unless expressly indicated in
the manual.
• Stop the bar feeder in accordance with the foreseen procedures before carrying out the
lubrication or other operations.
• Do use matches, lighters or torches as lightning means during operations with inflammable
fluids.
• Keep drain oil in suitable containers and deliver it to companies specialized in the storage
and disposal of polluting waste products.
• Avoid environmental pollution.
• Use original IEMCA spare parts only.
To Next Page
Loading...
