10 - GUIDE CHANNELS-BAR PUSHER-REVOLVING TIPS SMART320
EN
10 - Pag. 3 / 8
WARNING – CAUTION:
the application field of the collets for machining specific bar diameters in the
guide channels are indicated in the table in paragraph "SETUP ACCORDING TO
THE BAR TO BE MACHINED", Chap.5.
A bar diameter approximately 5 mm smaller than the guide channel diameter
may cause vibration and failure to the bar feeder. Therefore, it may be
necessary to slow down the bar rotation speed or to change the guide channel
diameter in order to obtain the best performance.
INFORMATION:
upon specific request, non standard collets with reduced thickness (which are
not mentioned in this table) may be supplied as well. Their durability is however
below the durability of standard collets.
To Next Page
Loading...
