Inovance H3U Series - Page 709

A.3 M8000 Flag and D8000 Register
708
Appendix
M
Element
Description
D
Element
Description
M8029 Multi-cycle instruction execution complete ag D8029 V0 register
System mode
M8030
The system disables the low battery alarm when
M8030 is ON.
D8030 Reserved
M8031
The system clears all volatile memories when
M8031 is ON.
D8031 Reserved
M8032
The system clears all non-volatile memories
when M8032 is ON.
D8032 Reserved
M8033
When M8033 is ON, all soft elements remain
unchanged when the device is stopped.
D8033 Reserved
M8034 When M8034 is ON, all outputs are OFF. D8034 Reserved
M8035 Command for forced running 1 D8035 Reserved
M8036 Command for forced running 2 D8036 Reserved
M8037 Command for forced stop D8037 Reserved
M8038 Reserved D8038 Reserved
M8039 Constant scan control D8039 Constant scan time, 0 by default, in the unit of ms
Step ladder
M8040 Transfer disabling D8040
Store the smallest action address numbers of S0
to S899 and S1000 to S4095 in D8040. Store the
greatest address numbers in D8047.
M8041 Transfer start D8041
M8042 Pulse output corresponding to startup input D8042
M8043 Homing end ag D8043
M8044 Mechanical origin action detected D8044
M8045 Output reset disabling D8045
M8046
After M8047 acts, if any of S0 to S899 and S1000
to S4095 is ON, M8046 is ON.
D8046
M8047 Valid STL monitoring [D8040 to D8047 valid] D8047
M8048
When M8049 is ON, if any of S900 to S999 is
valid, M8048 is valid.
D8048 Reserved
M8049 Valid signal alarm [D8049 valid] D8049
Store the smallest S900-S999 alarm address
numbers.
Disable interrupt
M8050 Driver I00□ (X0 pulse) interrupt disabling D8050 Reserved
M8051 Driver I10□ (X1 pulse) interrupt disabling D8051 Reserved
M8052 Driver I20□ (X2 pulse) interrupt disabling D8052 Reserved
M8053 Driver I30□ (X3 pulse) interrupt disabling D8053 Reserved
M8054 Driver I40□ (X4 pulse) interrupt disabling D8054 Reserved
M8055 Driver I50□ (X5 pulse) interrupt disabling D8055 Reserved
M8056 Driver I6□□ (timing) interrupt disabling D8056 Reserved
M8057 Driver I7□□ (timing) interrupt disabling D8057 Reserved
M8058 Driver I8□□ (timing) interrupt disabling D8058 Reserved
M8059 Driver counter interrupt disabling D8059 Reserved
System error detection
Element Name
Error
indicator
Running
M8060
I/O composition
error []
OFF RUN D8060 I/O address number of I/O composition error
M8061
PLC hardware
error
Blinking STOP D8061 PLC hardware error code number
M8062
PLC
conguration
error
OFF RUN D8062 PLC conguration error