Intel SC5650BCDP Technical Product Specification

Intel
®
Server Board S5500BC TPS Power and Environmental Specifications
Revision 1.8 Intel order number: E42249-009 109
Table 67. Voltage Regulation Limits
Parameter
Tolerance
Minimum
Nominal
Maximum
Units
+ 3.3V
- 5% / +5%
+3.14
+3.30
+3.46
V
rms
+ 5V
- 5% / +5%
+4.75
+5.00
+5.25
V
rms
+ 12V1,2
- 5% / +5%
+11.40
+12.00
+12.60
V
rms
- 12V
- 10% / +10%
-10.80
-12.00
-13.08
V
rms
+ 5VSB
- 5% / +5%
+4.75
+5.00
+5.25
V
rms
9.2.8 Dynamic Loading
The output voltages should remain within the limits for the step loading and capacitive loading
specified in the following table. The load transient repetition rate should be tested between 50
Hz and 5 kHz at duty cycles ranging from 10%-90%. The load transient repetition rate is a test
specification. The  step load may occur anywhere within the MIN load to the MAX load
conditions.
Table 68. Transient Load Requirements
Output
 Step Load Size
1
Load Slew Rate
Test Capacitive Load
+3.3 V
6.0 A
0.25 A/sec
250 F
+5 V
4.0 A
0.25 A/sec
400 F
12 V1+12 V2
18.0 A
0.25 A/sec
2200 F 1, 2
+5 VSB
0.5 A
0.25 A/sec
20 F
Notes:
1. The +12 V should be tested with 2200 F evenly divided between the four +12 V rails.
2. Step loads on each 12 V output may occur simultaneously.
9.2.9 Capacitive Loading
The power supply should be stable and meet all capacitive loading requirements. The following
table outlines these conditions.
Table 69. Capacitive Loading Conditions
9.2.10 Closed-Loop Stability
The power supply should be unconditionally stable under all line/load/transient load conditions,
including capacitive load ranges. A minimum of 45° phase margin and -10 dB gain margin is
required. The power supply manufacturer should provide proof of t-loop stability
Output
Minimum
Maximum
Units
+3.3 V
100
6,800
F
+5 V
10
4,700
F
+12 V 1, 2
220 each
11,000
F
-12 V
1
350
F
+5 VSB
20
2000
F

Intel SC5650BCDP Specifications

General

Brand	Intel
Model	SC5650BCDP
Category	Server
Language	English