Intel
®
Server Board S5500BC TPS Appendix C: POST Error Messages and Handling
Revision 1.8 Intel order number: E42249-009 135
Table 78. POST Error Messages and Handling
Keyboard component encountered a locked error.
Keyboard component encountered a stuck key error.
Fixed Media The SAS RAID firmware can not run properly. The user should
attempt to reflash the firmware.
PCI component encountered a PERR error.
PCI out of resources error
Processor 0x cache size mismatch detected.
Processor 0x stepping mismatch.
Processor 0x family mismatch detected.
Processor 0x Intel(R) QPI speed mismatch.
Processor 0x model mismatch.
Processor 0x speeds mismatched.
Processor 0x family is not supported.
Processor and chipset stepping configuration is unsupported.
CMOS/NVRAM Configuration Cleared
Passwords cleared by jumper
Password clear Jumper is Set.
Processor 01 unable to apply microcode update
Processor 02 unable to apply microcode update
Processor 0x microcode update not found.
Watchdog timer failed on last boot
OS boot watchdog timer failure.
Baseboard management controller failed self-test
Baseboard management controller failed to respond
Baseboard management controller in update mode
Memory component could not be configured in the selected RAS mode.
CLTT Configuration Failure Error.
DIMM_A1 failed Self Test (BIST).
DIMM_A2 failed Self Test (BIST).
DIMM_B1 failed Self Test (BIST).
DIMM_B2 failed Self Test (BIST).
DIMM_C1 failed Self Test (BIST).
DIMM_C2 failed Self Test (BIST).
DIMM_D1 failed Self Test (BIST).
DIMM_D2 failed Self Test (BIST).
DIMM_E1 failed Self Test (BIST).
To Next Page
Loading...
Need help?
General
