Intel
®
Server Board S5500BC TPS BIOS Setup Utility
Revision 1.8 Intel order number: E42249-009 81
Set system boot order by selecting the
boot option for this position.
Set the order of the legacy devices in
this group.
Appears when 1 or more
hard disk drives are in the
system.
Set the order of the legacy devices in
this group.
Appears when 1 or more
CD-ROM drives are in the
system.
Set the order of the legacy devices in
this group.
Appears when 1 or more
floppy drives are in the
system.
Set the order of the legacy devices in
this group.
Appears when 1 or more of
these devices are available
in the system.
Set the order of the legacy devices in
this group.
Appears when 1 or more of
these devices are available
in the system.
Add a new EFI boot option to the boot
order.
This option is only displayed
if an EFI bootable device is
available to the system (for
example, a USB drive).
Remove an EFI boot option from the
boot order.
If the EFI shell is deleted, it
is restored on the next
system reboot. It cannot be
permanently deleted.
If enabled, the BIOS only loads
modules required for booting EFI-
aware Operating Systems.
Grayed out when [SW
RAID] SATA Mode is
Enabled. SW RAID can only
be used in Legacy Boot
mode.
Use Legacy Video for
EFI OS
If enabled, the BIOS will use the
legacy video ROM instead of the EFI
video ROM.
Only appears when EFI
Optimized Boot is enabled.
If enabled, this continually retries non-
EFI-based boot options without
waiting for user input.
If enabled newly discovered USB
devices will be put to the top of their
boot device category.
If disabled newly discovered USB
devices will be put at the bottom of the
respective list
This option enables or
functionality.
If all types of bootable devices are installed in the system, then the default boot order is:
1. CD/DVD-ROM
2. Floppy Device
3. HDD Device
4. PXE device
5. BEV (Boot Entry Vector) Device
6. EFI Shell
To Next Page
Loading...
Need help?
General
