Intel
®
RAID Software User’s Guide 105
• “Removing a Drive or Changing the RAID Level of a Virtual Disk” on page 123
• “A Reconstruct operation begins on the virtual disk. You can monitor the progress of the
reconstruction in the Group Show Progress window. Select Manage -> Show Progress.”
on page 124
• “Changing Virtual Disk Properties” on page 124
• “Deleting a Virtual Disk” on page 125
• “Managing Configurations” on page 126
Create Virtual Drive
Use the Create Virtual Drive to create disk groups and virtual disks. The Create Virtual Drive
can create simple configurations automatically. For more complex configurations, the Create
Virtual Drive allows you to customize the configuration parameters according to your needs.
The Modify Drive Group allows you to easily change RAID levels, or to expand or reduce the
capacity of existing virtual drives.
Note: Unless you are logged on to a system with Administrator privileges, you cannot create or modify a
storage configuration.
Creating a Virtual Drive Using Simple Configuration
Simple configuration is the quickest and easiest way to create a new storage configuration.
When you select simple configuration mode, the system creates the best configuration possible
using the available drives
Note: You cannot created spanned drives using the simple configuration procedure. To create spanned
drives, use the advanced configuration procedure described in
“Creating a Virtual Drive Using
Advanced Configuration” on page 109
Follow these steps to create a new storage configuration in simple configuration mode.
1. Perform either of the following steps:
— Right click on the controller node in the device tree in the left frame of the Intel
®
RAID Web Console 2 window and select Create Virtual Drive
— Select the controller node and select Go To -> Controller -> Create Virtual Drive in
the menu bar, as shown in
Figure 48
To Next Page
Loading...
Need help?
General
