176 Intel
®
RAID Software User’s Guide
Table 14. MFI Messages
Number Type Description
0 Info Firmware initialization started (PCI ID %04x/%04x/%04x/%04x)
1 Info Firmware version %s
2 Fatal Unable to recover cache data from TBBU
3 Info Cache data recovered from TBBU successfully
4 Info Configuration cleared
5 Warning Cluster down; communication with peer lost
6 Info Virtual drive %s ownership changed from %02x to %02x
7 Info Alarm disabled by user
8 Info Alarm enabled by user
9 Info Background initialization rate changed to %d%%
10 Fatal Controller cache discarded due to memory/battery problems
11 Fatal Unable to recover cache data due to configuration mismatch
12 Info Cache data recovered successfully
13 Fatal Controller cache discarded due to firmware version incompatibility
14 Info Consistency Check rate changed to %d%%
15 Dead Fatal firmware error: %s
16 Info Factory defaults restored
17 Info Flash downloaded image corrupt
18 Critical Flash erase error
19 Critical Flash timeout during erase
20 Critical Flash error
21 Info Flashing image: %s
22 Info Flash of new firmware image(s) complete
23 Critical Flash programming error
24 Critical Flash timeout during programming
25 Critical Flash chip type unknown
26 Critical Flash command set unknown
27 Critical Flash verify failure
28 Info Flush rate changed to %d seconds
29 Info Hibernate command received from host
30 Info Event log cleared
31 Info Event log wrapped
To Next Page
Loading...
Need help?
General
