Chapter 7 — Commands
124 ESim for the PC4 and PF8 Printer Programmer’s Reference Manual
Remarks: This command affects the complete print image, including text,
bar codes, graphics, lines, and boxes, as well as the location f the
reference point, see “R - Set Reference Point” on page 104.
A label printed using the command ZT.
A label printed using the command ZB.
Example:
This example makes the printer print from the bottom of the
image, see command below.
ZB
Note: that printing a test label in the Test modes or using a U or
UP command resets the print direction to default (ZT).
EASYCODER PC4
Feed Direction
To Next Page
Loading...
