Chapter 7 — Commands
ESim for the PC4 and PF8 Printer Programmer’s Reference Manual 51
Errors occur if:
• data is not suitable to optional parameters => error 01
(syntax error).
• data is too long or out of range => error 03
(at length error).
• data does not fit in area specified => error 50.
M Manually controlled Pipe character:
Separator between data of linear and
two-dimensional composite part. Use this parameter
only in exceptional case.
Limit is any printable character.
Default is M|.
Data
1
|Data
2
The data area represents a string data field
surrounded by quotation-marks. Max data length is
relative chosen model type and data mode.
Invocation code in string follows the rules for
selectable Code 128, see“B - Standard Bar Codes”
on page 42. FNC2, FNC3, and FNC4 are not
allowed in composite code.
Data
1
String of primary data to linear component.
Limit is 48 digit maximum.
| Data separator pipe character.
Data
2
string of secondary data to two-dimensional
composite data.
Limit is all characters are in ISO 646.
b - EAN/UCC Command Parameter Description (continued)
Parameter Description
To Next Page
Loading...
