Javad Maxor - Bluetooth Module Firmware; Get Device Type

4-26 Maxor Operator’s Manual www.javad.com
OPERATION
Loading New Firmware
4
Notice: If you selected an incorrect RAM file, an error message
displays at the bottom of the dialog box. Reselect the
correct file.
11. Click File->Exit.
12. Clear the receiver’s NVRAM (see“Clearing the NVRAM” on
page 4-17) and update the almanac (“Collecting Almanacs” on
page 2-44
) after loading new firmware.
Bluetooth Module Firmware
Bluetooth module firmware is released as a compressed file that you
download and decompress. This file contains the following two files:
• btloader.ldr – the Bluetooth module RAM file
• btmain.ldp – the Bluetooth module Flash file
Notice: You must load both files when loading new firmware.
These files must come from the same firmware package.
1. In FLoader, click the Device tab and set th
e Device Type as “Receiver”.
Then click Get from Device for device information (Figure 4-19).
Figure 4-19. Get Device Type
2. Click the Program tab and set the Capture Method to “Soft Break
Capture” (recommended) (Figure 4-20 on page 4-27).