www.javad.com Maxor Operator’s Manual 2-39
CONFIGURATION
Radio Configuration
Enter the dial number, i.e. the phone number of the slave modem to
be dialed in to:
%% set,/par/modem/c/dial,<slave_mod_num>
where <slave_mod_num> stands for a specific phone number, e.g.
%% set,/par/modem/c/dial,89028354554
• Command 4.
Enter the 'wait on data from modem' timeout:
%% set,/par/modem/c/ rcvtimeout,5
• Command 5.
Enter the service word repeat period:
%% set,/par/modem/c/ sndtime,2
• Command 6.
Set the required modem mode:
%% set,/par/modem/c/ mode,master
– for the receiver configured as a rover,
%% set,/par/modem/c/ mode,slave
– for the receiver configured as a base.
The manual mode screen will show RE002%%
in response to each of
these commands. When finished, you should have seven responses in
the manual mode window's reply panel.
4. Now, the receiver is completely ready for field
operation. Just
switch the receiver on when in filed. The receiver will
automatically start working with the GSM modem.
How to configure a single GSM/GPRS modem with FieldView
Refer to the FieldView User's Manual for how to accomplish this task.
To Next Page
Loading...
