www.javad.com Maxor Operator’s Manual 3-13
SETUP AND MEASURING
Measuring with the Maxor
6. Move the Rover receiver along the selected trajectory.
7. Once the Rover receiver reaches the end point of the trajectory,
pause for seve
ral minutes.
8. When finished, press the FN key to stop logging data and turn off
the Rover.
Real-time Kinematic Measuring
Real-time kinematic (RTK) is a differential GPS process where
information, such as differential corrections, is transmitted in real-time from
a Base station to one or more Rover stations.
Setting up an RTK Base Station
To configure an RTK Base station using PCView, take the following
steps:
1. Set up the Base station receiver's antenna
as described in “Maxor
Receiver Setup” on page 3-2.
2. Connect an external modem to
port D for th
e Maxor receiver.
3. Press the power key on the recei
ver.
4. Check the STAT light for tracked satellites.
5. Connect your receiver and computer. See “Connecting the Maxor
and a Computer” on page 2-9 for this procedure.
6. Click Conf
iguration->Receive
r.
To Next Page
Loading...
