Javad Maxor - Select Power Output Modes - Ports; Select Power Output Modes - Slots

2-6 Maxor Operator’s Manual www.javad.com
CONFIGURATION
Powering the Maxor
2
6. Select the Power output modes Ports drop-down list to set power
output on the serial ports (Figure 2-4).
Figure 2-4. Select Power Output Modes – Ports
• On – the power board delivers voltage on pin one of all serial port
connectors when the receiver is turned on. If the receiver is turned off,
there will not be any power on the ports.
• Off – the power is absent, e
ven if the receiver is on.
• Always – the power board delivers voltage on p
in one of all serial port
connectors, even if the receiver is off.
7. Select the Power output modes
Slots drop-down list to set power
output on internal slots (Figure 2-5).
Figure 2-5. Select Power Output Modes – Slots
• On – all slots have power if the receiver is turned on.
• Off – internal slots do not have power, even if the recei
ver is turned on.
• Always – internal slots have power, even if the receiver is turned off.
8. Vi
ew the Volta
ges information (Figure 2-6).
Figure 2-6. View Voltages Information
• External – displays the external power supply’s voltage.
• On Board – displays
the voltage drawn by the receiver board.
• Battery A – displays the vo
ltage of battery A.