www.javad.com Maxor Operator’s Manual 2-9
CONFIGURATION
Connecting the Maxor and a Computer
Connecting the Maxor and a Computer
To configure, manage files, or maintain the Maxor, you need to connect the
receiver and a computer using an RS232 cable, and start PCView. In addition, if
an USB port is available on your Maxor, you can use an USB cable and a
computer with the JNS USB driver for such connection.
Once you have established a connection between the receiver a
nd the computer,
you will be able to:
• Configure the receiver and its components
• Send commands to the receiver
• Download files from the receiver's memory
• Use FLoader to load new firmware to the receiver
• Use PCView to load OAFs and configuration files to the receiver
Establishing a Wireless Connection
The Maxor receiver contains Bluetooth® wireless technology that allows
file transfer and synchronization between the receiver and any other
external device that supports Bluetooth® wireless technology; for example,
an IPAQ, or a computer with USB-to-Bluetooth® adapter or PCMCA-to-
Bluetooth® adapter installed.
Notice:
Changing the receiver’s Port B default settings will affect
the Bluetooth® link. The default settings for Port B are
115200 bps, 8 data bits, 1 stop bit, no parity, and no
handshaking.
The Maxor and external device connection procedure varies slightly
depending
on the type of external device used. In general, the connection
procedure is as follows:
Notice:
Refer to your Bluetooth®-enabled external device
documentation for more detailed connection information.
1. Turn on a Bluetooth®-enabled external device and your receiver. The
default e
xternal device mode is Master; the receiver’s Bluetooth®
module mode is Slave.
2. Instruct the external device (Master) to search for the receiv
er (Slave).
To Next Page
Loading...
