Javad Maxor - Chapter 2. Configuration Guide

www.javad.com Maxor Operator’s Manual 2-1
CONFIGURATION 2
This chapter discusses how to configure the Maxor, including instructions for
charging the receiver, connecting to a computer, configuring the receiver’s
MinPad interface, on-board radio modem, and Bluetooth® module. This
information is described in the following sections:
Powering the Maxor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-2
Charging the Maxor . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-8
Connecting the Maxor and a Computer . . . . . . . . . . . . . . . . . . . 2-9
Maxor Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-14
MinPad Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-19
Radio Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-26
Bluetooth® Module Configuration . . . . . . . . . . . . . . . . . . . . . . 2-54
Collecting Almanacs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-58
Chapter Tip: Before you can use your Maxor receiver, you need to:
1. Charge the batteries. See “Charging the Maxor” on page 2-8.
2. Configure the various parts of your receiver. See:
• “Connecting the Maxor and a Computer” on page 2-9,
• “Maxor Configuration” on page 2-14,
• “MinPad Configuration” on page 2-19, and
• “Radio Configuration” on page 2-26 (if applicable).
3. Collect an almanac. See “Collecting Almanacs” on page 2-44.