www.javad.com Maxor Operator’s Manual 2-27
CONFIGURATION
Radio Configuration
1. Navigate to the location of the Modem-JNS program and double-
click the Setup.exe icon.
2. Keep the default installation location or select a new location. Click
Finish.
3. Clic
k OK to complete the instal
lation.
Configuring a Base Station’s JNS 2W UHF 410-470 radio
transceiver
For Maxor, the integrated JNS 2W UHF 410-470 radio transceiver
provides TX/RX UHF communications between a Base Station and
Rover. To configure the UHF radio modems, have the following ready:
• Computer running Windows® 98 or newer
• Modem-JNS version 1.7 or newer
• Serial cable (or Bluetooth® wireless technology capabil
ities)
1. Co
nnect the computer and receiver using an RS232 cable or
Bluetooth® wireless technology.
2. Tu
rn on the receiver.
3. Open Modem-JNS and select the COM port the receiver is
co
nnecte
d to.
4. Click Connect.
There are two scenarios for configuring the radio-modem:
• with a dedicated channel
• with the Free Channel Scan (FCS) mode
To Next Page
Loading...