Javad Maxor - Radio Configuration

2-26 Maxor Operator’s Manual www.javad.com
CONFIGURATION
Radio Configuration
2
Radio Configuration
The internal radio in your Maxor can be configured differently depending on
your needs and working conditions. The software program required to configure
the radio modem differs depending on your receiver configuration, and allows
you to:
• access the internal modem
• configure the modem
• check or change the mo
dem config
uration
The following sections provide basic radio configuration information for UHF
and sin
gle GSM radio modems.
For the detailed description of the
Mode
m-JNS software see Modem-JNS
Software Manual on our website (http://www.javad.com).
Notice: Your receiver may be configured without a radio modem.
If this is the case, please skip to “Bluetooth® Module
Configuration” on page 2-40
.
Configuring a JNS 2W UHF 410-470 radio transceiver
Modem-JNS is JNS’s radio modem configuration utility for modems
embedded in Maxor family receivers. Modem-JNS provides the following
functions:
• Connecting a PC to an integrated radio modem via a serial port or
Bluetooth® wireless technology.
• D
isplaying information about the radio modem installed in the receiv
er.
• Programming the radio modem’s settings.
Installing Modem-JNS
Modem-JNS is available from the Support area (Free Software
section) of JNS website (http://www.javad.com). If downloading the
program from the website, extract the program files into a folder on
your hard drive.
Notice: Use Modem-JNS version 1.7 or newer to correctly
configure the receiver.