Javad Maxor - Receiver Configuration - Minpad Tab

2-16 Maxor Operator’s Manual www.javad.com
CONFIGURATION
Maxor Configuration
2
•Enter the File name prefix. Use the last three digits of the receiver serial
number.The receiver's serial number is on the back panel of the receiver.
Figure 2-15. Receiver Configuration – MinPad Tab
If your jobsite is in an area that has obstructions (buildings, trees, etc.), and/or
the antenna location is near reflective objects, configure the receiver to reduce
errors from these sources.
4. Click the Advanced tab on the Receiver Configuration screen and then
click the Multipath Reduction subtab. Enable the following boxes, and
click Apply (Figure 2-16 on page 2-17):
• Code multipath reduction