Juniper MX10004 - Page 131

CAUTION: Mount the chassis securely, and then install line cards and other
components in the secured chassis.
CAUTION: Before mounng the router on a rack or cabinet, have a qualied technician
verify that the rack is strong enough to support the router's weight and is adequately
supported at the installaon site.
CAUTION: If you are mounng mulple units on a rack, plan to mount the rst router at
the boom of the rack. Mount the heaviest unit at the boom of the rack. Mount the
other units from the boom of the rack to the top in decreasing order of weight:
heaviest unit on the boom, lightest unit at the top.
To mount the router:
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the
other end to a site ESD point.
2. Aach the mounng blades to the front rack posts by using six rack mount screws appropriate for
your rack and a screwdriver (see Figure 37 on page 121).
Figure 37: Aach the Mounng Blades
121