Juniper MX10004 - Page 139

1. Wrap and fasten one end of the Electrostac Discharge (ESD) grounding strap around your bare
wrist, and connect the other end of the strap to the ESD point on the front of the chassis. See Figure
45 on page 129.
Figure 45: ESD Point for MX10004 Chassis Front
1— ESD point
2. Insert all opcs.
3. Li the front door and align the capve screws in the door with holes in the chassis ange. Fasten
the door to the chassis and rack using the capve screws, and hand ghten. See Figure 46 on page
129.
Figure 46: Aach Front Door Using the Capve Screws
129