6. Grasp both handles and spread them apart. The SFB slides about a quarter of the way out of the slot.
See Figure 82 on page 184.
Figure 82: Join the Ejector Handles
7. Grasp the ejector handles with one hand and place your other hand under the SFB for support as you
slide the SFB out of the slot.
CAUTION: The SFB surface and handles may be hot. Allow a few minutes for the
surface and handles to cool by pulling the SFB halfway out of the chassis. Wear proper
protecve, heat-resistant gloves while removing an SFB.
8. Support the SFB as you rotate the SFB 90 degrees and place it on the anstac mat with the printed
circuit board (PCB) facing upward. Be careful to handle the SFB by the ejectors. Be careful not to
bump or handle the SFB by the connectors. If you don’t have an anstac mat, have another person
help you slide the anstac bag over the SFB before you place it on a stable surface.
CAUTION: Do not stack hardware components on top of one another aer you
remove them. Place each component on an anstac mat resng on a stable, at
surface.
184
To Next Page
Loading...
