Juniper MX10004 - Page 227

NOTE: The two handles on the side of the chassis are meant only to help guide the empty
chassis out of the base and rear brackets; they are not for liing.
4. On each side, hold the boom of the chassis and carefully li it up from the mounng tray aached
to the rack.
5. Carefully li the chassis out of rack. If you have a pallet jack, move the router onto the pallet jack.
See Figure 104 on page 217.
Figure 104: Li the MX10004 Without Using a Mechanical Li
6. Carefully move the chassis to its new locaon.
Aer moving the router to its new locaon, install the components in the chassis or store the
components in anstac bags.
217