Juniper MX10004 - Page 46

Table 9: Fan Tray LEDs on an MX10004 (Connued)
Name Color State Descripon
Amber Blinking An error has been detected in SFB 5.
Replace the SFB as soon as possible.
The SFB is located behind the right fan
tray and is the right-most SFB in the
group of 3. To maintain proper airow
through the chassis, leave the fan tray
installed in the chassis unl you are
ready to replace the SFB.
Amber Blipping Beacon is enabled.
None O The SFB is oine.
Fan Tray Controller LEDs
The fan tray controller LEDs are visible only when the associated fan tray is removed. The fan tray
controller LEDs are located on the right of the controller panel. Figure 18 on page 36 shows the
locaon of the LEDs on the JNP10004-FTC2 fan tray controller faceplate.
Figure 18: Fan Tray Controller LEDs on an MX10004
1—
Fan tray controller power
2—
Fan tray controller status
Table 10 on page 37 describes the funcons of the fan tray controller LEDs.
36