Juniper MX10004 - Page 57

Table 16: JNP10K-PWR-AC2 Power Cable Specicaons for 20-A Input (Connued)
Locale Cord Set Rang Plug Standard Spare Juniper Model
Number
Graphic
South Africa 16 A, 250 VAC SANS 164/1 CBL-JNP-SG4-SA
Switzerland 16 A, 250 VAC CEI 23-50 CBL-JNP-SG4-SZ
JNP10K-PWR-AC2 Power Cable Specicaons for 30-A Input
The JNP10K-PWR-AC2 HVAC or HVDC power supplies require a high-current cable assembly when set
for 30-A input. One end of the cable has an Anderson APP-400 connector, while the other end of the
cable is bare wire. See Figure 21 on page 48 and Table 17 on page 48. These cables are separately
orderable and are not shipped automacally with JNP10K-PWR-AC2 orders. An example of the right-
angle cable and connector is shown in Figure 23 on page 49.
47