Juniper MX10004 - Page 83

Cables and
connectors
TIP: You can use the Hardware Compability Tool to nd informaon about the
pluggable transceivers that your Juniper Networks device supports.
See the list of supported transceivers for the MX Series at MX Series Supported
Transceivers.
MX10K-LC480 supports 1-Gbps Copper SFP modules in all the ports. You must use
shielded RJ45 cables with 1-Gbps copper SFP modules.
You must install the MX10K-LC480 line card in the MX10008 and MX10016 routers
along with the front panel with lter to meet the EMI Class-A emission standards.
The following applies to a router (MX10008 or MX10016) installed with the front panel:
•
We recommend that you use only 16 ports per line card with copper SFP modules -
the last 8 ports on the MIC0 (0/16 through 0/23) and the rst 8 ports on the MIC1
(1/0 through 1/7).
•
The MX10008 router supports a maximum of 128 copper SFP modules of 1 Gbps
capacity.
• The MX10016 router supports a maximum of 192 copper SFP modules of 1 Gbps
capacity.
NOTE: The 1-Gbps copper SFP modules on the MX10K-LC480 line card do not support
Precision Time Protocol (PTP) or Synchronous Ethernet funconality.
73