Juniper MX10004 - Page 82

Power requirements
• Power consumpon at dierent temperatures when all ports are congured in 10-
Gbps speed:
25° C: 420 W (without MACSec), 430 W (with MACSec)
40° C: 430 W (without MACSec), 450 W (with MACSec)
55° C: 450 W (without MACSec), 480 W (with MACSec)
• Power consumpon at dierent temperatures when all ports are congured in 1-
Gbps speed:
25° C: 360 W (without MACSec), 370 W (with MACSec)
40° C: 370 W (without MACSec), 390 W (with MACSec)
55° C: 390 W (without MACSec), 420 W (with MACSec)
LEDs PWR LED
• Steady green—Line-card power is ok.
• Steady red—Line-card power-on has failed.
• O—Line card is not receiving power.
STS LED
• Steady green (blinking green when the beacon or the port locaon is on)—Line card is
online.
•
Blinking green—The line card is boong.
•
Steady red (blinking red when the beacon or the port locaon is on)—Line card is
faulty or an alarm has been raised.
•
O—Line card is disabled or oine.
Port LED
• O—Port does not have a transceiver module.
• Steady green (blinking green when the beacon or the port locaon is on)—Port link is
up with no alarms or failures.
• Steady amber (blinking amber when the beacon or the port locaon is on)—Port link
is down because the port is disabled through the CLI or the port encountered errors
such as loss of signal, local fault, or remote fault.
72