Juniper MX10016 - Replacing an MPC; Removing an MPC

Replacing an MPC
IN THIS SECTION
Removing an MPC | 222
Installing an MPC | 225
Installing the Cable Management System | 227
Removing an MPC
Before you remove a line card from the router chassis:
•
Ensure that you have taken the necessary precautions to prevent electrostatic discharge (ESD) damage
(see “Prevention of Electrostatic Discharge Damage” on page 303).
•
Ensure that you know how to handle and store the line card (see Handling and Storing MX10008 Line
Cards, RCBs, and SFBs).
222